How to draw Arc and Circle in Pulsonix?

Problem:- 1

I am using Pulsonix PCB Design tool. And I have drawn my schematics of two pages. Now, I am not able to save my design.What I do?

Solution:-1a

I think you are using a trial version. It has limitation. That is why you are struggling. Buy full version.

Solution:-1b

Pulsonix PCB design tool would not let you save file if you have duplicates. Please review your design.

Problem:-2 

I do not see status bar in my Pulsonix tool, how to turn it on?

Solution:-

You can activate it from View > Status Bar.

Problem:-3 

How to draw arc and circle in Pulsonix ?

Solution:-

Open the page and draw a line as shown in below image. Lets say you would like to draw a circle for 100mils dia. Then that line should be 100mils long. Set your grid 25mils ( press "G") and you can watch your length while drawing your line in status bar ( at bottom) If you don't have then activate it from the View > Status Bar.

 Now right click on the line which you have just drawn.

Then click at arc and then click at circle. Now, that line will convert into circle of dia 100mils.

For arc. Click at Arc and then angle 45 or angle 180 or may be you just would like to pick your own value then click at enter angle, then enter your angle value and you are done.

Please note:- For those who don't know :- dia stands for Diameter